Kinetis Bootloader  2.0.0
Common bootloader for Kinetis devices
MK80F25615/src/application_config.h
1 /*
2  * Copyright (c) 2013, Freescale Semiconductor, Inc.
3  * All rights reserved.
4  *
5  * Redistribution and use in source and binary forms, with or without modification,
6  * are permitted provided that the following conditions are met:
7  *
8  * o Redistributions of source code must retain the above copyright notice, this list
9  * of conditions and the following disclaimer.
10  *
11  * o Redistributions in binary form must reproduce the above copyright notice, this
12  * list of conditions and the following disclaimer in the documentation and/or
13  * other materials provided with the distribution.
14  *
15  * o Neither the name of Freescale Semiconductor, Inc. nor the names of its
16  * contributors may be used to endorse or promote products derived from this
17  * software without specific prior written permission.
18  *
19  * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND
20  * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
21  * WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
22  * DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR
23  * ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
24  * (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES;
25  * LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
26  * ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
27  * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS
28  * SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
29  */
30 #ifndef __APPLICATION_CONFIG_H__
31 #define __APPLICATION_CONFIG_H__
32 
34 // Definitions
36 
37 /* Serial Port Info */
38 
39 /**************************************************************************
40  * Note:
41  *
42  * Because of the changes to the UART modules, we can no longer define
43  * the TERM_PORT as a base pointer. The uart functions have been modified
44  * accommodate this change. Now, TERM_PORT_NUM must be defined as the
45  * number of the UART port desired to use
46  *
47  * TERM_PORT_NUM = 0 -- This allows you to use UART0; default pins are
48  * PTA14 and PTA15
49  *
50  * TERM_PORT_NUM = 1 -- This allows you to use UART1; default pins are
51  * PTC3 and PTC4
52  *
53  * TERM_PORT_NUM = 2 -- This allows you to use UART2; default pins are
54  * PTD2 and PTD3
55  *
56  *************************************************************************/
57 #define TERM_PORT_NUM 0
58 
59 #define TERMINAL_BAUD 19200
60 #undef HW_FLOW_CONTROL
61 
62 #endif // __APPLICATION_CONFIG_H__
63 // EOF