Overview
========
The pflash example shows how to use flash driver to operate program flash:
Toolchain supported
===================
- IAR embedded Workbench 7.60.1
- Keil MDK 5.18a
- GCC ARM Embedded 2015-4.9-q3
- Kinetis Development Studio IDE 3.2.0
- Atollic TrueSTUDIO 5.4.2
Hardware requirements
=====================
- Mini/micro USB cable
- FRDM-KL03Z board
- Personal Computer
Board settings
==============
No special settings are required.
Prepare the Demo
================
1. Connect a USB cable between the host PC and the OpenSDA USB port on the target board.
2. Open a serial terminal with the following settings:
- 9600 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
3. Download the program to the target board.
4. Either press the reset button on your board or launch the debugger in your IDE to begin running the demo.
Running the demo
================
When the example runs successfully, you can see the similar information from the terminal as below.
PFLASH example Start
Flash Information:
Total Program Flash Size: xx KB, Hex: (xx)
Program Flash Sector Size: xx KB, hex: (xx)
Flash is UNSECURE!
Erase a sector of flash
Successfully Erased Sector xx -> xx
Program a buffer to a sector of flash
Successfully Programmed and Verified Location xx -> xx
End of PFLASH example
Customization options
=====================
